ISO IEC 24735-2021 pdf Information technology — Office equipment — Method for measuring digital copying productivity

4 Test parameters and conditions 4.1 Copying device setup Place the copying device on a horizontal surface and set up the copying device according to the manufacturer’s recommendations. The copying device shall be fully enclosed in its normal exterior cover. All image and copying modes should be at their factory preset configuration for the copying device. It is assumed that the settings listed in Table 1 are common to all copying devices. These listed settings shall be set to the manufacturer’s default or preset condition for the device. If a device has settings not listed in Table 1, they too shall be set to default settings. For copying devices that have additional print quality and digital image processing features, those features shall be set to match their normal default condition and included in the result reporting. Multiple copy output shall be collated. If collated output is not included in the default settings, follow the manufacturer ’s recommendation for obtaining collated output. In the case that collation settings do affect performance, the faster of the results should be reported. As with other settings, the test report shall disclose the manner in which collation was achieved. Single and multiple copy output will be ordered according to “default settings ”. It is assumed that “default settings ” will yield original order output for a dual output order device that supports both original order and reverse order output. If the default settings on a dual output order device yields reverse order output, then testing using original order output is required for the 1 set + 30 seconds test and the 1 set + 4 minutes test runs, optional for 1 set test.
If the system has automatic media detect (automatic paper type selection), it can be disabled, and paper used in the test shall be selected manually. This shall be noted in the full detailed report (see Annex B ). The following preset values in the test will be noted on this report format. Additional optional tests with non-default settings or configurations may be run.